This is default featured slide 1 title
This is default featured slide 2 title
This is default featured slide 3 title
This is default featured slide 4 title
This is default featured slide 5 title

Info of Tree Trimming

• Safety harness-this is an important piece of equipment that a tree trimmer needs for their job. This piece of equipment ensures the tree climbers safety if they should fall. The most common type of safety harness is called the climbing saddle. It has nylon straps that securely fit about their thighs and waist along with an anchor in which to attach a rope with a carabineer. A carabineer is a coupling link with a safety closure.
• Climbing rope-this is used to help the trimmer too safely and efficiently climb the tree. The rope attaches to the carabineer on the safety harness, which holds the trimmer in the tree. This lessens the risk of injury should the tree trimmer fall. The climbing rope needs to be of good quality.
• Chainsaw-this machine comes in different sizes to accommodate large and small jobs. A small chainsaw has a fourteen or sixteen-inch guide bar and weighs around eight pounds. This size is good for doing trim work and removing limbs. The larger chainsaw can weigh up to ten pounds and have a guide bar of eighteen to sixty inches. These are necessary for tree removals and large limbs.
• Pole saws-The seare small chainsaws on an extension pole and can increase the reach of a tree trimmer up to an additional twelve feet. They are available in electric and gas motors. They are usually lightweight so a tree trimmer can use them for an extended period of time without causing excessive strain on your arm.
• Chipper-this machine s used to chip brush and branches into bark size pieces for easier disposal or for resale. A chipper comes in two styles for industrial or personal use. The personal size chipper is compact, small and can be towed behind a regular truck for doing small jobs. For industrial size jobs, the tree trimmer should have a chip truck. With this type of chipper the brush can be chipped directly, back in the truck. This will allow for easier clean and transport.